Prerequisites - Proxim ORiNOCO AP-700 User Manual

Installation and Initialization

Prerequisites

The LED indicators exhibit the following behavior:
Indication
Solid Green AP image running.
Blinking Green n/a
Solid Amber The Bootloader is loading the
application software.
Blinking Amber The AP is reloading.
Solid Red Power On Self Test (POST)
running.
Blinking Red Rebooting.
Prerequisites
Before installing an AP-700, you need to gather certain network information. The following table identifies the information
you need.
Network Name (SSID of the
wireless cards)
AP's IP Address
HTTP Password
CLI Password
SNMP Read Password
SNMP Read-Write Password
SNMPv3 Authentication
Password
SNMPv3 Privacy Password
Security Settings
Authentication Method
Authentication Server Shared
Secret
Authentication Server
Authentication Port
Power
Wireless interface is preparing
for use.
Wireless interface is transmitting
or receiving wireless packets.
n/a
n/a
n/a
n/a
You must assign the Access Point a Network Name before wireless users can
communicate with it. The clients also need the same Network Name. This is not the
same as the System Name, which applies only to the Access Point. The network
administrator typically provides the Network Name.
If you do not have a DHCP server on your network, then you need to assign the
Access Point an IP address that is valid on your network.
Each Access Point requires a read/write password to access the web interface. The
default password is "public".
Each Access Point requires a read/write password to access the CLI interface. The
default password is "public".
Each Access Point requires a password to allow get requests from an SNMP
manager. The default password is "public".
Each Access Point requires a password to allow get and set requests from an SNMP
manager. The default password is "public".
If Secure Management is enabled, each Access Point requires a password for sending
authenticated SNMPv3 messages. The default password is "public". The default
SNMPv3 username is administrator, with SHA authentication, and DES privacy
protocol.
If Secure Management is enabled, each Access Point requires a password when
sending encrypted SNMPv3 data. The default password is "public".
You need to determine what security features you will enable on the Access Point.
A primary authentication server may be configured; a backup authentication server is
optional. The network administrator typically provides this information.
This is a password shared between the Access Point and the RADIUS authentication
server (so both passwords must be the same), and is typically provided by the network
administrator.
This is a port number (default is 1812) and is typically provided by the network
administrator.
Wireless Interface
(802.11a/b/g radio)
AP-700 User Guide
Ethernet
Ethernet interface is connected
at 100 Mbps with no traffic.
Ethernet interface is connected
at 100 Mbps with traffic.
Ethernet interface is connected
at 10 Mbps with no traffic.
The Ethernet interface is
connected at 10 Mbps with
traffic.
n/a
n/a
17