5. Lift the release levers on each side of the SAS cage and pull it out of the server
6. Note where the SAS signal cables are connected on the backplane, and
7. Grasp the top edge of the SAS backplane and pull it up slightly while lifting the
8. If you are instructed to return the SAS backplane, follow all packaging
Replacing the SAS backplane
To install the replacement SAS backplane, complete the following steps:
1. Connect the signal cables to the replacement backplane.
140
IBM System x3800 Type 8866: Problem Determination and Service Guide
Release
levers
until it stops.
disconnect the cables.
backplane away from the SAS hard disk drive cage.
instructions, and use any packaging materials for shipping that are supplied to
you.