Table of Contents
Advertisement
To add an alphanumerical display, which may be used
1.9.2 Guided creation of a personalization
In this brief instruction chapter, we will explain the operations which are necessary in
order to create a personalization window.
La station used as a reference will be a TX500 (TLC300, PTXLCD, PJ500MC)
In order to add an instrument to indicate the output forward power.
1) Press F4 in order to enable the EDIT mode
2) Click with the right button of your mouse on the area where you want to add the
command.
3) Select "Add Angular Gauge" from the "Add Control" menu
4) The selection window will be displayed
Choose node:
DO NOT USE
A – Choose the
module
B – Choose type of
measurement
C – Choose
measurement
D – Control boxes
In the box "A" choose the module "1-2" whic corresponds to the PJ500.
5) Choose between the "B" buttons, on "InAna" in order to have the list of analogical
measurements displayed.
6) In the "C" box select the "Fwd Power" measurement.
"000 (A) TX1 Fwd Power" means: "000" which is the input number, "(A)" indicates
that the input is analogical, the remaining is the name of the input (which is the
same as box "Text:" from the group "D".
7) These options are valid only for the "Angular Gauge" control: boxes from group
"D".
If you wish to replace the end scale of the analogical meter, write the required
value in the "End scale" box.
User Manual
Rev. 1.0 - 17/01/03
SCM-TLC
OK button
Cancel
button
27 / 50
Advertisement
Table of Contents
