Table of Contents
Advertisement
7.2.1 Balanced Analog Input
Each of these connectors can be used to connect eight balanced analog signals to
the device, as indicated in the table; each input accepts a voltage between 2 and
12V.
The table summarizes the functions to which a few balanced analog inputs of this
card are dedicated.
Input from No. 1 to No.4 are used for setting, with the relative trimmer, the level of
forward and reflected power of the connected machines.
The inputs No.1 and No.2 are used from firmware for the alarms generation of forward
and reflected power.
Limit voltages ranging from a minimum of 2V to a maximum of 12V can be applied to
the balanced inputs. However, during data processing, the CPU works with a
theoretical limit value of 5V. For this reason, there are eight trimmers (RV1-RV8),
next to the connector, one for each input, which are used to adjust the limit value set
externally to that of the internal circuitry.
To prevent the non-linearity introduced by protective diodes, do not exceed the 4V
limit.
The foregoing table shows each balanced input with the relative adjustment trimmer.
7.2.2 Digital/Analog Input
The meaning of these inputs change in according to the type of system to telemetry.
User Manual
Numero pin
Livello di potenza diretta 1
2 (+), 14 (−)
Livello di potenza riflessa 1
3 (+), 16 (−)
Livello di potenza diretta 2
5 (+), 17 (−)
Livello di potenza riflessa 2
6 (+), 19 (−)
Livello di potenza diretta 3
8 (+), 20 (−)
Livello di potenza riflessa 3
9 (+), 22 (−)
Livello di potenza diretta 4
11 (+), 23 (−)
Livello di potenza riflessa 4
12 (+), 25 (−)
1, 4, 7, 10, 13, 15,
Massa
18, 21, 24
Rev. 1.0 - 05/05/03
Significato
TLC2000
Trimmer di reg.
RV1
RV2
RV3
RV4
RV5
RV6
RV7
RV8
21 / 50
Advertisement
Table of Contents
