TLC2000
10.2 GSet - General settings
This menu is used to set the general and communication parameters of the change
over system.
•
Uart Adr.:
•
Baud Rate: sets the data transmission speed, from 1200 to 19200 baud.
•
Modem:
1)
2)
3)
4)
•
Status:
1)
2)
•
Reset Alm.: completely clears the alarm report and switches off the "GENERAL
•
RTC:
10.3 Info - Information about system configuration
Displays some parameters characteristic of system configuration. These parameters
cannot be modified.
40 / 50
sets the address of the change over unit; this is important in a system
in which there are several telemetry and remote control devices
operating in series;
sets the type of modem:
Not Present:
no modem connected;
Present:
data-phone modem;
Pager:
data-phone modem with alarm indication in the form of
pager messages;
GSM:
GSM modem with alarm indication in the form of SMS
messages;
sets the system control mode:
Remote:
remote control;
Local:
local control;
ALARM" LED on the main panel;
allows you to set the time and date of the internal Real Time Clock.
Rev. 1.0 - 05/05/03
User Manual