Table of Contents
Advertisement
TLC2000
•
Repeat the operation with the Dip-switch 2, than with the Dip-switch 3, verifying
that are modified respectively the input Type 8=analogic 10 and Type 8=analogic
11 of the telemetry board and the led "Digital Input #2" and "Digital Input #3".
•
Place in OFF position the Dip-switch 4 of SW2.
This test can be carried out without power supplying placing the inputs in Pull-up.
11.6.4 Rly Output
Insert the Dip-switches 7 and 8, and verify that giving a commando through the two
buttons "OFF LED" and "ON LED" that makes reference to the first relay of the
telemetry card to which is connected the card it is turn on and turn off the led on the
test card.
Remember to supply to the test card the voltage of 12 V necessary to its operation
and to connect well the 25 poles cables between the same connectors.
50 / 50
Rev. 1.0 - 05/05/03
User Manual
Advertisement
Table of Contents
