Table of Contents
Advertisement
SCM-TLC
Enable Input
Enable Display
Name
Measure Unit
Conversion Type
End Scale
Start Scale
Max
Nominal
Min
Format
Input Mask
Resolution ADC 1024
Type
Text for Max
Text for Min
With such settings, the voltage present at the input will be displayed.
1.7.2 How to modify the database
If the user needs to modify the measurements on already existing databases, the
parameters to modify are the following:
•
Conversion Type
•
End Scale
•
Max
•
Enable Input
•
Enable Display
Conversion Type: determins the calculations to make with the received datum.
The different algorythms were created in function of the requirements of the equipment
manufactured by R.V.R. and include power measurements, voltage and current, logical
status, etc.
End Scale: indicates the maximum value displayed corresponding to the maximum
voltage applied at the input.
18 / 50
Si
Si
Analogical 1
V
TENS/CORR
5
0
6
0
0
#0.0
###
1
???
???
Rev. 1.0 - 17/01/03
It is displayed on the Telecon grids
Name of the measurement
Name of the measurement
Measure unit, Volt
Conversion for voltage and current
measurements
Value displayed when input at the maximum
Value displayed when input at the minimum
Value after which the alarmis generated
Not used parameter
Value under which alarm is generated
the datum has a number after the comma
Not used parameter
ADC resolution (useful for calculations)
1 = analogical input
Text displayed when at the maximum (only
digital input)
Text displayed when at the minimum (only
digital input)
User Manual
Advertisement
Table of Contents
