Wheel Bearing (For 2Wd Model) - Suzuki Wagon R Plus RB310 Service Manual

12) Install brake drums (right & left). For details, refer to steps 3)
to 8) of "Brake Drum Installation" in Section 5C.
13) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to Section 5.)
14) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
Wheel bolt (a): 95 N·m (9.5 kg-m, 69.0 lb-ft)
15) Upon completion of all jobs, depress brake pedal with about
300 N (30 kg, 66 Ibs) load three to five times so as to obtain
proper drum-to-shoe clearance. Adjust parking brake cable.
(For adjustment, refer to Section 5.)
16) Install console box.
17) Lower hoist and bounce vehicle up and down several times
to stabilize suspension.
18) Tighten right and left trailing arm rear nuts, shock absorber
lower bolts and lateral rod rear axle side nut to specified
torque.
NOTE:
When tightening these nuts and bolts, be sure that vehi-
cle is off hoist and in non loaded condition.
Tightening torque
Trailing arm rear nut
(e): 80 N·m (8.0 kg-m, 58.0 lb-ft)
Shock absorber lower bolt (f): 63 N·m (6.3 kg-m, 45.5 lb-ft)
Lateral rod nut (axle side) (g): 50 N·m (5.0 kg-m, 36.5 lb-ft)
19) Check to ensure that brake drum is free from dragging and
proper braking is obtained.
20) Perform brake test (foot brake and parking brake).

Wheel Bearing (for 2WD Model)

Removal
1) Remove rear brake drum, referring to "Rear Brake Drum
Removal" in Section 5C.
REAR SUSPENSION 3E-13