Table of Contents
Advertisement
6) Remove reverse shaft bolt (1) with washer.
7) Remove case bolts (2) from outside and another bolts from
clutch housing side.
8) Tapping left case (3) flanges with plastic hammer, remove
left case.
9) Pull out reverse gear shaft (1) with washer (2), then take off
reverse idler gear (3).
10) Remove reverse gear shift lever bolts (4) and reverse gear
shift lever (5).
11) Pull out 5th & reverse gear shift guide shaft (6) together with
5th & reverse gear shift shaft (7).
12) Tapping input shaft end with plastic hammer, push it out as
assembly from case a little, then take out input shaft assem-
bly (1), counter shaft assembly (2), high speed gear shift
shaft (3) and low speed gear shift shaft (4) all at once.
Installation
1) Install differential assembly (1) into right case (2).
2) Insert VSS (3) with grease applied to its new O-ring, then
tighten it with bolt.
Grease 99000-25010
MANUAL TRANSAXLE (M13 ENGINE) 7A2-25
Advertisement
Table of Contents
