Table of Contents
Advertisement
43) Measure O/D and 2nd coast brake piston stroke.
• Measure dimension "a" from end face of transaxle case to O/
D and 2nd coast brake rear plate (1) using straightedge and
micrometer caliper.
• Measure dimension "b" from O/D and 2nd coast brake piston
(2) to rear cover assembly mating surface using straightedge
and micrometer caliper.
• Calculate piston stroke from measured value of dimensions
"a" and "b".
• Piston stroke = "a" – "b"
O/D and 2nd coast brake piston stroke
standard: 0.65 – 1.05 mm (0.026 – 0.041 in.)
When piston stroke is out of specification, select O/D and 2nd
coast brake rear plate with proper thickness from among the list
below and replace it.
Available O/D and 2nd coast brake rear plate thickness
Thickness
1.8 mm (0.071 in.)
2.0 mm (0.079 in.)
2.2 mm (0.087 in.)
2.4 mm (0.094 in.)
2.6 mm (0.102 in.)
5.0 mm
44) After applying A/T fluid to new 2nd brake gaskets (1), install
them to transaxle case (2).
45) After applying A/T fluid to reverse clutch drum thrust bearing
(1), install it to forward and reverse clutch assembly (2).
AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-191
Identification mark
1
2
3
4
5
Advertisement
Table of Contents
