Transaxle Case Plug; Accumulator O-Ring Dimension; Accumulator Piston Identification; Accumulator Spring Identification - Suzuki Wagon R Plus RB310 Service Manual

7B1-196 AUTOMATIC TRANSAXLE (M13 ENGINE)
67) After applying A/T fluid to new O-ring, fit it to transaxle case
plug (1). Then install the transaxle case plug to transaxle
case (2).
Tightening torque

Transaxle case plug

(a): 7.5 N·m (0.75 kg-m, 5.5 lb-ft)
68) Install new O-rings to each accumulator piston and apply A/T
fluid to them.

Accumulator O-ring dimension

O-ring name
B1 accumulator O-ring (Large) (2)
C1 accumulator O-ring (Large) (2)
C2 accumulator O-ring (Large) (2)
(Above three O-rings are same.)
B1 accumulator O-ring (Small) (4)
C1 accumulator O-ring (Small) (6)
C2 accumulator O-ring (Small) (6)
(Above two O-rings are same.)
NOTE:
Make sure that O-rings are not twisted or caught when
installing.
69) Install B1, C1, C2 accumulator pistons and springs.

Accumulator piston identification

Piston name
B1 accumulator piston (3)
C1 accumulator piston (5)
C2 accumulator piston (8)

Accumulator spring identification

Spring name
B1 accumulator No.2 spring (1)
C1 accumulator No.2 spring (7)
C2 accumulator No.2 spring (9)
Inside Section
diameter diameter
29.4 mm 2.6 mm
(1.16 in.) (0.10 in.)
19.7 mm 2.6 mm
(0.78 in.) (0.10 in.)
21.8 mm 2.6 mm
(0.86 in.) (0.10 in.)
Identification
(Embossed letters on piston)
SB-1
S2C-1
S2C-2
Color of identification
paint
Pink
Light Blue
Yellow