Suzuki Wagon R Plus RB310 Service Manual page 649

7B1-80 AUTOMATIC TRANSAXLE (M13 ENGINE)
DTC Troubleshooting
Step
1 Was "Automatic Transaxle Diagnostic Flow
Table" performed?
2 Check TCC solenoid valve resistance
1) Turn ignition switch OFF
2) Disconnect valve body harness connector
on automatic transmission.
3) Check for proper connection to solenoid at
"WHT/BLU" circuit.
4) Check resistance of solenoid valve. See
Fig.
Resistance between TCC solenoid valve
terminals of transmission side valve body
harness connector: 11 – 15
(68°F)
Resistance between TCC solenoid valve
terminals of transmission side valve body
harness connector and transmission body:
Infinity
Is check results satisfactory?
3 Check TCC solenoid valve circuit for ground
short
1) Disconnect TCM connectors.
2) Check for proper connection to TCM at ter-
minals "E13-5".
3) If connection is OK, check continuity
between terminal "E13-5" of disconnected
harness side TCM connector and ground.
Is continuity indicated?
Fig. for Step 3.
1. Valve body harness connector on harness
2. Valve body harness connector on transaxle
3. Ground (transaxle)
Action
Ω
at 20°C
1
Yes
Go to Step 2.
Go to Step 3.
"WHT/BLU" circuit
shorted to ground.
2
2
5 4 3 1
10 9 8 7
6
No
Go to "Automatic Tran-
saxle Diagnostic Flow
Table" in this section.
Replace TCC solenoid
valve or lead wire.
Intermittent trouble or
faulty TCM. Check for
intermittent referring to
"Intermittent and Poor
Connection" in Section
0A. If OK, substitute a
known-good TCM and
recheck.
3