Differential Adjustment - Suzuki Wagon R Plus RB310 Service Manual

7A2-42 MANUAL TRANSAXLE (M13 ENGINE)
5) Hold differential assembly with soft jawed vise (3), install
final gear (2) as shown in figure and then tighten bolts (1)
with thread lock cement applied to specified torque.
NOTE:
Make sure to install final gear in correct installing direc-
tion.
CAUTION:
Use of any other bolts than specified ones is prohibited.
"A": Thread lock cement 99000-32110
Tightening torque
Final gear bolt (a): 90 N·m (9.0 kg-m, 65.0 lb-ft)
4. Groove

Differential Adjustment

Judging from abnormality noted before disassembly and what is
found through visual check of component parts after disassembly,
prepare replacing parts and proceed to reassembly. Make sure
that all parts are clean.
1) Assemble differential gear and measure thrust play of differ-
ential gear as follows.
Differential gear thrust play
: 0.03 – 0.31 mm (0.001 – 0.012 in.)
• For left side
a) Hold differential assembly with soft jawed vise and apply
measuring tip of dial gauge to top surface of gear.
b) Using 2 screwdrivers (1), move gear (2) up and down and
read movement of dial gauge pointer.
Special tool
(A): 09900-20606
(B): 09900-20701