Table of Contents
Advertisement
6A2-38 ENGINE MECHANICAL (M13 ENGINE)
1
11) Install water pump pulley.
12) Install cylinder head cover referring to "Cylinder Head Cover
13) Install oil pan referring to "Oil Pan and Oil Pump Strainer
14) Install crankshaft pulley (1). Tighten bolt (2) to specified
Special tool
(A): 09917-68221
Tightening torque
Crankshaft pulley bolt (a): 150 N·m (15.0 kg-m, 108.5 lb-ft)
15) Install engine assembly to vehicle referring to "Engine
Timing Chain Cover Inspection
Oil seal
• Check oil seal (1) lip for fault or other damage.
NOTE:
When installing new oil seal, press fit to timing chain
cover (2) by using special tool (Bearing installer) as
shown in the figure.
Special tool
(A): 09913-75810
"a"
Drive in dimension
"a": 1.5 mm (0.06 in.)
Timing chain cover
Inspect strainer (1) of oil passage for driving intake cam timing
sprocket assembly (VVT actuator).
If clog or foreign matter exists, clean strainer.
Removal and Installation" in this section.
Removal and Installation" in this section.
torque. To lock crankshaft pulley, use special tool with it as
shown in the figure.
Assembly Removal and Installation" in this section.
Replace as necessary.
Advertisement
Table of Contents
