Table of Contents
Advertisement
Adjustment before unit assembly
Differential Side Bearing Preload
1) After applying A/T fluid to differential assembly, fit it to tran-
saxle case.
2) Install torque converter housing to transaxle case, then
tighten bolts (1) to specified torque.
Tightening torque
Torque converter housing bolt
(a): 33 N·m (3.3 kg-m, 24.0 lb-ft)
3) Measure bearing preload (a) by using a special tool.
Special tool
(A): 09928-06050
Differential side bearing preload (starting torque)
In the case of new bearing
(a): 0.8 – 1.4 N·m (8.0 – 14.0 kg-cm, 0.58 – 1.01 lb-ft)
In the case of reused bearing
(a): 0.4 – 0.7 N·m (4.0 – 7.0 kg-cm, 0.29 – 0.51 lb-ft)
4) If bearing preload is out of specification, select shim with
suitable thickness from among the list below and replace it.
Then adjust differential side bearing preload within specifica-
tion.
AUTOMATIC TRANSAXLE (M13 ENGINE) 7B1-177
Advertisement
Table of Contents
