Table of Contents
Advertisement
3B-4 MANUAL RACK AND PINION
Engine rear mounting bolt
Steering gear case mounting bolt and nut
Steering shaft joint bolt
Tie rod end lock nut
Tie rod end nut
Wheel bolt
7) Reinstall cover (1) removed previously to steering shaft joint.
8) Put back floor mat as it was.
9) Install both wheels and tighten wheel bolts to specified
10) Lower hoist.
11) Check toe setting. Adjust as required (refer to "Front Wheel
12) Tighten both tie rod end lock nuts to specified torque.
Tightening Torque Specifications
Fastening part
torque.
Tightening torque
Wheel bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
Alignment" in Section 3A).
Tightening torque
Tie rod end lock nut (a): 45 N·m (4.5 kg-m, 32.5 lb-ft)
N•m
55
25
28
45
40
95
Tightening torque
kg-m
lb-ft
5.5
40.0
2.5
18.0
2.8
20.5
4.5
32.5
4.0
29.0
9.5
69.0
Advertisement
Table of Contents
