Static Routing - ZyXEL Communications GS2210-8 User Manual

38.2 Static Routing

Click I P Applica t ion > St a t ic Rout in g in t he navigat ion panel t o display t he screen as shown.
Figure 228 I P Applicat ion > St at ic Rout ing
To enable I Pv4 st at ic rout e, configure t he st at ic rout e set t ings in t he I P Applica t ion > St a t ic
Rout ing > I Pv4 St a t ic Rout e screen.
38.3 IPv4 Static Route
Click I P Applica t ion > St a t ic Rou t in g > I Pv4 St a t ic Rou t e in t he navigat ion panel t o display t he
screen as shown.
Figure 229 I P Applicat ion > St at ic Rout ing > I Pv4 St at ic Rout e
The following t able describes t he relat ed labels you use t o creat e a st at ic rout e.
Table 160 I P Applicat ion > St at ic Rout ing > I Pv4 St at ic Rout e
LABEL
Act ive
Nam e
Dest inat ion I P
Address
I P Subnet
Mask
Chapter 38 Static Route
DESCRIPTION
This field allows you t o act ivat e/ deact ivat e t his st at ic rout e.
Ent er a descript ive nam e ( up t o 10 print able ASCI I charact ers) for ident ificat ion purposes.
This param et er specifies t he I P net work address of t he final dest inat ion.
Ent er t he subnet m ask for t his dest inat ion. Rout ing is always based on net work num ber. I f
you need t o specify a rout e t o a single host , use a subnet m ask of 255.255.255.255 in t he
subnet m ask field t o force t he net work num ber t o be ident ical t o t he host I D.
GS2210 Series User's Guide
331