Link Aggregation Control Protocol - ZyXEL Communications GS2210-8 User Manual

Table 62 Advanced Applicat ion > Link Aggregat ion > Link Aggregat ion Set t ing ( cont inued)
LABEL
Crit eria
Port
Group
Apply
Cancel

17.3.1 Link Aggregation Control Protocol

Click Adva n ce d Applica t ion > Lin k Aggr e ga t ion > Link Aggr e ga t ion Se t t ing > LACP t o
display t he screen shown next . See
dynam ic link aggregat ion.
Chapter 17 Link Aggregation
DESCRIPTION
Select t he out going t raffic dist ribut ion t ype. Packet s from t he sam e source and/ or t o t he sam e
dest inat ion are sent over t he sam e link wit hin t he t runk. By default , t he Swit ch uses t he sr c-
dst - m a c dist ribut ion t ype. I f t he Swit ch is behind a rout er, t he packet 's dest inat ion or source
MAC address will be changed. I n t his case, set t he Swit ch t o dist ribut e t raffic based on it s I P
address t o m ake sure port t runking can work properly.
Select sr c- m a c t o dist ribut e t raffic based on t he packet 's source MAC address.
Select dst - m a c t o dist ribut e t raffic based on t he packet 's dest inat ion MAC address.
Select sr c- dst - m a c t o dist ribut e t raffic based on a com binat ion of t he packet 's source and
dest inat ion MAC addresses.
Select sr c- ip t o dist ribut e t raffic based on t he packet 's source I P address.
Select dst - ip t o dist ribut e t raffic based on t he packet 's dest inat ion I P address.
Select sr c- dst - ip t o dist ribut e t raffic based on a com binat ion of t he packet 's source and
dest inat ion I P addresses.
This field displays t he port num ber.
Select t he t runk group t o which a port belongs.
Note: When you enable the port security feature on the Switch and configure port security
settings for a port, you cannot include the port in an active trunk group.
Click Apply t o save your changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses t hese
changes if it is t urned off or loses power, so use t he Sa ve link on t he t op navigat ion panel t o
save your changes t o t he non- volat ile m em ory when you are done configuring.
Click Ca n ce l t o begin configuring t his screen afresh.
Dynam ic Link Aggregat ion on page 148
GS2210 Series User's Guide
153
for m ore inform at ion on