Table of Contents
Advertisement
4.2.2 Recovery Factory Setting Page
The "Recovery Factory Setting" Page can recovery module to factory setting. First, Pleas click
"Open Port" button to make a serial connection between BLE-USB and host PC. Second,
Please click the "Recovery" button to start recovery process, and the utility will show a
message after recovery process is complete. If the recovery process is fail, BLE-USB need re-
power and do it again.
Figure 4-12. Recovery success
Figure 4-13. Recovery fail
4.3
on Utility
Test Module
The module test page was shown in the Figure 4-14.The utility supports two types for the
module test. The "connection Mode" is used to test module in the connection mode (refer to
1.3.2). The "Broadcast Mode" is used to test the module in the broadcast mode (refer to 1.3.1)
Figure 4-14. Module test page
4.3.1 Connection Mode
The main page of connection mode was shown in the Figure 4-15. This page can send or
BLE-USB, USB to Bluetooth Low Energy Converter (Ver. 1.0, Oct/6/2016) 54
Advertisement
Table of Contents
