Error Code Table - ICP DAS USA BLE-USB User Manual

3.1.25

Error Code Table

Error code Mode
01
02
03
AT
04 command
mode
05
06
07
C1
Connection
mode
C2
A1
A2
Broadcast
A3
mode
A4
A5
3.2 The Broadcast Mode Command
The module also supports few commands in broadcast mode. User can send this command and
didn't need to enter the command mode. The prefix "+AD" must
beginning of each command line, and the character <CR> is used to finish a command line.
Set packet
+ADV: xxx <CR>
Description
The parameter of AT command is error
This command didn't support read mode
This command didn't support write mode
This command didn't support execution mode
Unknown AT command
Unknown AT command mode
Set baud rate fail
Not connect to peer device
Illegal master
Header error
Broadcast packet is too long
Broadcast packet is null
This features was not supported in broadcaster role
This features was not supported in Observer role
Start transmission
+ADS<CR>
Figure 3-4. Start transmission in broadcast mode
BLE-USB, USB to Bluetooth Low Energy Converter (Ver. 1.0, Oct/6/2016) 44
be included at the
Stop transmission
+ADP<CR>