Table of Contents
Advertisement
Switch BLE-USB to connection mode and Slave
The OTA only work when the BLE-USB is the Salve in the connection mode. You can use
the utility (refer to 4.2.1.) to switch the role and transmission mode. The AT command
(refer to
3.1.20
and 3.1.23) also can do it.
Figure 4-37. Switch to Slave
Connect the BLE-USB by your computer
You need to connect the BLE-USB by your Bluetooth interface on your computer. The
device name is BUSB-XXX. The "XXX" can change by AT command (refer to 3.1.15) or
the utility (refer to 4.2.1). If the Bluetooth interface didn't scan any device, please re-
power the BLE-USB. Ensure your device is Advertising so the PC can find it.
Figure 4-36. Disable Master Identification mechanism by utility
by utility
BLE-USB, USB to Bluetooth Low Energy Converter (Ver. 1.0, Oct/6/2016) 61
Figure 4-38. Switch to connection mode
by utility
Advertisement
Table of Contents
