Table of Contents
Advertisement
4.10 General Error code for all command
If the Error response function on the I-7530A-MR_MR module is set to be
"Yes"(that means enable) via the I-7530A-MR Utility when configuration, the I-
7530A-MR will automatically send the error code to the RS-232/485/422 device
or the host PC through the RS-232/485/422 media when the I-7530A-MR
produces an error message during the operation mode. The meanings of these
error codes are given below:
Error
Description
code
1
Invalid header
2
Invalid length
3
Invalid checksum
4
Buffer overrun
5
Timeout
I-7530A-MR Modbus RTU to CAN Converter User's Manual (Version 1.07, 06/2016) ------------- 61
Table 4-8: Error code table
Possible causes & solutions
The header of the RS-232/485/422
command string is not
"t","T","e","E","S","P0", "P1","P2" nor "RA".
The numbers of data of the CAN message
does not match the data length of the CAN
message. For example:
Error: t001512345<CR>
Right: t00150102030405<CR>
The
checksum
command string does not match with the
checksum calculated by the I-7530A-MR. For
example:
Error: t0012112209<CR>
Right: t00121122FD<CR>
The transmission buffer verrun is happened,
users should retransmit the message later
when this module is normal.
The ASCII command strings are sent
incomplete.
For example:
Error: T0018
Right: T0018<CR>
of
the
RS-232/485/422
Advertisement
Table of Contents
