Protocols and standards
RFC 3973, Protocol Independent Multicast-Dense Mode (PIM-DM): Protocol Specification(Revised)
•
•
RFC 4601, Protocol Independent Multicast-Sparse Mode (PIM-SM): Protocol Specification (Revised)
RFC 5059, Bootstrap Router (BSR) Mechanism for Protocol Independent Multicast (PIM)
•
Configuring PIM-DM
PIM-DM configuration task list
Task at a glance
(Required.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuration prerequisites
Before you configure PIM-DM, configure any unicast routing protocol so that all devices in the domain
are interoperable at the network layer
Enabling PIM-DM
Enable IP multicast routing before you configure PIM.
With PIM-DM enabled on interfaces, routers can establish PIM neighbor relationship and process PIM
messages from their PIM neighbors. When you deploy a PIM-DM domain, enable PIM-DM on all
non-border interfaces of the routers.
IMPORTANT:
All the interfaces on a device must operate in the same PIM mode.
To enable PIM-DM:
Step
1.
Enter system view.
2.
Enable IP multicast routing.
3.
Enter interface view.
4.
Enable PIM-DM.
Enabling PIM-DM
Enabling the state refresh feature
Configuring state refresh parameters
Configuring PIM-DM graft retry timer
Configuring common PIM features
Command
system-view
multicast routing-enable
interface interface-type
interface-number
pim dm
70
Remarks
N/A
By default, IP multicast routing is
disabled.
N/A
By default, PIM-DM is disabled.