Table of Contents
Advertisement
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
9. Go to [Register].
10. Select by pressing the left start button.
11. Select a receiver. Confirm by pressing the left start button. The display shows [Registering] while the
process is ongoing.
12. When the receiver has found the transmitter, all relay LEDs flash. Press the receiver Select button.
Function LEDs 1-7 flash 3 times. The relay LEDs go off.
13. All Function LEDs light for approx. 1 second.
Number of transmitters registered in the receiver
RELAY LED NO.
STATUS
1
ON
2
ON
3
ON
4
ON
5
ON
6
ON
7
ON
Example: Relay LED 2 lights, which means that 2 transmitters are currently registered in the receiver.
ERASE
Erase a transmitter from the receiver
NOTE! If a transmitter is lost or becomes seriously damaged, it is possible to erase it from the receiver.
We do not recommend this way. Contact your representative for assistance.
NOTE! If the transmitter already have receivers registered, we recommend that you erase all receivers
from the transmitter before starting the replacement. The receiver will automatically be stored in the
same position as it was stored in the old transmitter. If this position is not available, the replacement will
not take place.
1. Make sure that the stop button is pressed.
2. Pull out the stop button.
The top LED lights (green when the battery capacity is good, red when the battery capacity is poor).
3. Press the right start button. Keep pressed.
4. Press the stop button.
5. Release the right start button.
The top LED flashes (green when the battery capacity is good, red when the battery capacity is poor)
when in menu mode.
NO. OF TRANSMITTERS
1
2
3
4
5
6
7 or more
- 24 -
Hide quick links:
Advertisement
Table of Contents
