Fcc Statement - Tele Radio Tiger T2 Installation Instructions Manual

Industrial radio remote controls, receivers / transmitters
Table of Contents

Advertisement

 
The radio module
 
Function
Each receiver and transmitter unit in the Tele Radio Tiger product range, contains a radio module that is
specifically designed to match a Tele Radio Tiger unit in terms of physical dimensions, connection
points, voltage levels, signal interface etc. To use the radio modules in non Tele Radio products is not
permitted.
The radio modules are designed to interface directly to the main board of the receiver/transmitter unit.
They are power supplied by the main board and the radio circuit operates strictly according to
instructions from a microprocessor on the main board. The radio circuit config-uration is stored in a
flash memory on the radio module.
A receiver/transmitter unit with a defective/no radio module will give an error message immediately
after power up, and it will not be
possible to start a radio session.
 
Cross reference
Cross reference of radio modules and corresponding products:
Tiger unit Radio module:
 
T00011-24
TR304
R00004-10
TR283
 
 
 
Installation
 
Installation instructions for TR304
1. Make sure that the transmitter unit is turned off.
2. Open the enclosure.
3. Assemble TR304 to the 2 x 12 pole socket connector on the bottom side of the main board.
 
Installation instructions for TR283
1. Make sure that the receiver unit is turned off.
2. Open the enclosure.
3. Connect the 2x12 pole socket connector of TR283 directly to the main board.
 

FCC statement

 
Statement for warning:
To satisfy FCC RF exposure requirements, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during device
operation.
To ensure compliance, operations at closer than this distance is not recommended.
Les antennes installées doivent être situées de facon à ce que la population ne puisse
y être exposée à une distance de moin de 20 cm. Installer les antennes de facon à ce
que le personnel ne puisse approcher à 20 cm ou moins de la position centrale de l'
antenne.
La FCC des éltats-unis stipule que cet appareil doit être en tout temps éloigné d'au
moins 20 cm des personnes pendant son functionnement.
Chapter 4: FCC/ IC INFORMATION
-
-
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

R00004-05T00011-24T00009-22R00004-10

Table of Contents