Specifying The Process Pressure; Determining The Installation Factor - Endress+Hauser Proline t-mass A 150 Operating Instructions Manual

Commissioning
50
Parameter overview with brief description
Parameter
Select gas type Select the gas type for the
measurement application.
10.4.2

Specifying the process pressure

Navigation path
"Setup" menu → Process pressure
Parameter overview with brief description
Parameter/
Process pressure Process pressure value for
calculating pressure-dependent gas
properties
10.4.3

Determining the installation factor

Navigation path
"Setup" menu → Installation factor
Parameter overview with brief description
Parameter
Installation factor The factor is multiplied by
the mass flow to correct
sub-optimum installations
Description Selection/
User entry
Gas type choose list
• Air
• Argon Ar
• Carbon dioxide CO2
• Nitrogen N2
Description
0.5 to 41.6 bar a
(7.3 to 603 psi a)
Description Selection/
User entry
0 to 9
Proline t-mass A 150 HART
Factory setting
Air
Selection/ Factory setting
User entry
Country-dependent:
1.0130 bar a
(14.692 psi a)
Factory setting
1
Endress+Hauser