R/L Adjustment - Fronius TPS 320i Operating Instructions Manual

Setting range
Factory setting
Process parame- The following parameters can be set and displayed for the process control:
ters for process
regulation
Fusion penetration stabiliser
for setting the max. permitted change in the wire feed speed, so as to keep the fusion pen-
etration stable or constant with variable stickout
The fusion penetration stabiliser parameter is only available when the option WP PMC
(Welding Process Puls Multi Control) or WP LSC (Welding Process Low Spatter Control)
has been enabled on the power source.
Unit
Setting range
Factory setting

R/L adjustment

Align the welding circuit resistance (R) and welding circuit inductivity (L) if one of the fol-
lowing components of the welding device is changed:
-
-
-
-
-
-
Prerequisites for R/L adjustment
The welding system must be complete: closed welding loop with torch and torch hosepack,
wire-feed units, grounding (earthing) cable, interconnecting hosepacks.
Performing R/L adjustment
1
70
0 - 9.9
0.5
m/min
off / 0; 0.1 - 10.0
off / 0
Torch hosepacks
Interconnecting hosepacks
Grounding (earthing) cables, welding cables
Wire-feed units
Welding torches, electrode holders
Push-pull units
AlMg 5
1
Select the "Process parameters" button in the left-hand ribbon
R/L adjustment
2