Welding Parameters - Fronius TPS 320i Operating Instructions Manual

Welding parameters

Welding parame- The following welding parameters for MIG/MAG pulse synergic welding can be set and dis-
ters for MIG/MAG played by pressing the "Welding" button:
pulse synergic
welding
Current recomm value
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Voltage recomm value
Unit
Setting range
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Material command value
Unit
Setting range
Feeder command value
Unit
Setting range
Arc length correction
for correcting the arc length
Setting range
Factory setting
-
0
+
Pulse/dynamic correction
for correcting the pulsing range of a pulsed arc
Setting range
Factory setting
-
0
+
1)
A
depends on the welding process and welding program selected
1)
V
depends on the welding process and welding program selected
1)
mm in.
2)
0.1 - 30.0 mm 0.004 - 1.18
1)
m/min ipm.
2)
0.5 - max. 19.69 - max
-10 - +10
0
shorter arc length
neutral arc length
longer arc length
-10 - +10
0
lower droplet detachment force
neutral droplet detachment force
higher droplet detachment force
2)
2)
65