Siemens SIPROTEC 7SA522 Manual page 599

RIO file
RSxxx-interface
SCADA Interface
Service port
Setting parameters
SI
SI_F
SICAM SAS
SICAM SC
SICAM WinCC
Single command
Single point indica-
tion
SIPROTEC
SIPROTEC 4 device
SIPROTEC 4
variant
7SA522 Manual
C53000-G1176-C155-3
Relay data Interchange format by Omicron.
Serial interfaces RS232, RS422/485
Rear serial interface on the devices for connecting to a control system via IEC or
PROFIBUS.
Rear serial interface on the devices for connecting DIGSI (for example, via modem).
General term for all adjustments made to the device. Parameterization jobs are exe-
cuted by means of DIGSI or, in some cases, directly on the device.
→ Single point indication
→ Single-point indication fleeting → Transient information, → Single point indication
Modularly structured station control system, based on the substation controller →
SICAM SC and the SICAM WinCC operator control and monitoring system.
Substation Controller. Modularly structured substation control system, based on the
SIMATIC M7 automation system.
The SICAM WinCC operator control and monitoring system displays the state of your
network graphically, visualizes alarms, interrupts and indications, archives the network
data, offers the possibility of intervening manually in the process and manages the
system rights of the individual employee.
Single commands are process outputs which indicate 2 process states (for example,
ON/OFF) at one output.
Single indications are items of process information which indicate 2 process states (for
example, ON/OFF) at one output.
The registered trademark SIPROTEC is used for devices implemented on system
base V4.
This object type represents a real SIPROTEC 4 device with all the setting values and
process data it contains.
This object type represents a variant of an object of type SIPROTEC 4 device. The
device data of this variant may well differ from the device data of the source object.
However, all variants derived from the source object have the same VD address as
the source object. For this reason they always correspond to the same real SIPRO-
TEC 4 device as the source object. Objects of type SIPROTEC 4 variant have a variety
of uses, such as documenting different operating states when entering parameter set-
tings of a SIPROTEC 4 device.
Glossary
599