Figure 67. Removing the network daughter card
Next step
Install the Network Daughter
Installing the network daughter card
Prerequisite
Follow the safety guidelines listed in
Steps
1
Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2
Align the captive screws at the back-end of the card with the screw holes on the system board.
3
Press the touch points on the card until the card connector is firmly seated on the system board connector.
4
Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Card.
Safety
instructions.
Installing and removing system components
121