General tab
Click the
tab (see figure 29,
General
for front panel lockout (executive) mode, auto switch mode, and factory reset.
Figure 29.
General Tab
Executive Mode panel
Unlock the Front Panel — Click the
2
disable front panel lockout (executive) mode.
Lock the Front Panel — Click the
3
panel lockout (executive) mode (see
on page 15).
Auto-input Switching panel
Auto-input Switching — Click the
4
enable auto switch mode. Two settings are available for this mode.
Click the
•
Priority to highest active input number
automatically switch to the highest numbered active input.
Click the
•
Priority to lowest active input number
automatically switch to the lowest numbered active input.
Factory reset
Factory Reset — Click the
2
settings except for firmware.
NOTE: This is the same as the
page 22).
XTP T USW 103 Switcher • XTP System Configuration Software
) to open the
1
General
Unlock Front Panel
Lock Front Panel
Front Panel Lockout Mode (Executive Mode)
Enable Auto-input Switching
button to reset the switcher to factory
Factory Reset
E
SIS command (see
ZXXX
screen. It contains settings
radio button (default) to
radio button to enable front
check box to
radio button to
radio button to
Reset mode
on
33