General tab
Click the
tab to open the general screen. It contains settings for executive mode,
General
auto switch mode, and factory reset.
Figure 17.
General Tab
Executive mode section
Unlock the front panel — Click the
executive mode.
Lock the front panel — Click the
mode (see
Setting the Front Panel Lockout Mode (Executive Mode)
Auto-input Switching section
Auto-input switching — Click the
auto switch mode. Two settings are available for this mode.
Click the
Priority to highest active input number
switch to the highest numbered active input.
Click the
Priority to lowest active input number
switch to the lowest numbered active input.
Factory reset
Click the
button to reset the transmitter to factory settings except for
Factory Reset
firmware.
NOTE: This is the same as the
Unlock Front Panel
radio button to enable executive
Lock Front Panel
Enable Auto-Input Switching
radio button to automatically
radio button to automatically
E
SIS command.
ZXXX
XTP T USW 103 • XTP System Configuration Software
radio button (default) to disable
on page 11).
check box to enable
24