Remote Power - Extron electronics XTP T USW 103 User Manual

Remote power

The XTP T USW 103 can be powered remotely through an XTP Power Injector or through
an XTP matrix switcher.
ATTENTION:
• XTP remote power is intended for indoor use only. No part of the network that uses
XTP remote power should be routed outdoors.
•
XTP à distance est destiné à une utilisation en intérieur seulement. Aucune partie
du réseau qui utilise l'alimentation XTP à distance ne peut être routée en extérieur.
Power injector
To power the XTP T USW 103 remotely with an XTP Power Injector, power a connected
receiver locally (see Local power
XTP cable run along the XTP ports (see the XTP Power Injector User Guide at
www.extron.com for more installation information).
POWER 2
1
12V AUDIO
1.0 A MAX
RGB HDMI
INPUTS
Extron
XTP T USW 103
XTP Transmitter
100-240V 50/60 Hz
Power ---A MAX
Extron
XTP PI 100
XTP Power
Injector
POWER
12V
1A MAX
Extron
12V Local Power
XTP R HDMI
Supply
XTP Receiver
Figure 10. Typical Point-to-Point Application with Remote Power
NOTE: The power injector provides remote power up to 330 feet with a shielded twisted
pair cable with 24 AWG wire.
XTP matrix switcher
XTP matrix switchers have a fixed amount of power available to provide remote power to
connected XTP devices (see the XTP matrix switcher user guide at
more details). To manage available power from the XTP matrix switcher, use the XTP System
Configuration Software with the matrix switcher.
on page 11) and connect an XTP Power Injector to the
OVER XTP REMOTE
SIG LINK
3
RS-232 IR CONTACT RS-232
R
HDMI XTP OUT LAN
Tx Rx G Tx Rx 1 2 3 G Tx Rx G
Remote
Power
XTP XTP PWR
PWR
Shielded Twisted
Pair Cable
SIG LINK OVER XTP
AUDIO
RS-232 IR
ON
OFF
XTP IN Tx Rx G Tx Rx
LAN HDMI
XTP T USW 103 Switcher • Installation
XTP R HDMI
OUTPUTS RELAYS
AUDIO
L R 1 2
RESET
+ − + − S/PDIF
www.extron.com for
13