Edid - Extron electronics XTP T USW 103 User Manual

EDID

`
To manage EDID on the XTP T USW 103, use the XTP System Configuration Software (see
EDID Minder
memory location, select a pre-defined EDID, or use EDID from a display connected to a
receiver. EDID stored in the user memory location can come from the display connected to
a receiver or a custom EDID imported through the XTP System Configuration Software.
NOTE: In matrix applications, EDID on the switcher is assigned by the matrix switcher
Reset Mode
Use the recessed
restore factory-shipped firmware.
Figure 12.
Mode Mode Activation
Hold down the recessed
button while applying power to the
device.
NOTE: After a mode 1 reset,
Factory
1
update the device with the
Reset
latest firmware version. DO
NOT operate the firmware
version that results from this
mode reset.
on page 35). The XTP T USW 103 can record and save EDID in a user
using the XTP System Configuration Software.
button on the rear panel of the switcher (see figure 12,
Reset
POWER
1
12V
AUDIO
1.0 A MAX
RGB
INPUTS
Rear Panel Reset Button
Reset Mode Summary
The device reverts to the factory
Reset
default firmware.
SIG LINK
2 3
HDMI HDMI
XTP OUT
Result
NOTE: If you do not want
to update the firmware or
perform a mode 1 reset by
mistake, cycle power to
the device to return to the
firmware version running prior
to the reset.
XTP T USW 103 Switcher • Operation
) to
A
A
OVER XTP REMOTE
RS-232 IR CONTACT
RS-232
LAN
Tx Rx G Tx Rx 1 2 3 G Tx Rx G
Purpose and Notes
Use mode 1 to return
to factory firmware for
a single power cycle if
an incompatibility issue
arises.
R
16