Extron electronics XTP T USW 103 User Manual page 14

XTP output connector — Connect a twisted pair cable to the RJ-45 connector
D
labeled on the XTP T USW 103 (see
XTP OUT
input connector on another XTP device to pass all signals (see
and Recommendations
Digital video
•
Digital audio
•
Bidirectional RS-232 and IR commands
•
Remote power
•
Ethernet communication
•
System communication
•
Signal LED indicator — Lights green when the XTP T USW 103
outputs a video signal or a test pattern.
Link LED indicator — Lights yellow when XTP devices are connected
and communication is established.
ATTENTION:
• Do not connect this connector to a computer data or telecommunications
network.
•
Ne connectez pas ce connecteur à un réseau de données informatiques ou à
un réseau de télécommunications.
• XTP remote power is intended for indoor use only. No part of the network that
uses XTP remote power should be routed outdoors (see
page 13).
• XTP à distance est destiné à une utilisation en intérieur seulement. Aucune
partie du réseau qui utilise l'alimentation XTP à distance ne peut être routée en
extérieur (voir Remote power
E
LAN connector — Connect a control device or device to be controlled to the RJ-45
connector labeled
LAN
communication through this pass-through port. LEDs on the connector indicate link and
activity status.
F RS-232 Over XTP port — To pass bidirectional serial signals between
XTP-compatible devices, connect a control device to the 5-pole captive
figure
screw connector (see
3 poles labeled "RS-232."
IR Over XTP port — To transmit and receive IR signals (up to 56 kHz),
connect a control device to the 5-pole captive screw connector (see
figure 2, on page 4). This port includes the 2 poles labeled "IR" and
F
shares the ground pole with the RS-232 port.
NOTE: RS-232 and IR data can be transmitted simultaneously (see
Over XTP Communication
Contact closure connector — Connect an Extron KP 6 Keypad Remote Control or
G
similar device to the 3.5 mm, 4-pole captive screw connector (see
page 4). The first three ports are used for selecting inputs 1 through 3 when
momentarily shorted to the ground port (see
page 9 for wiring considerations).
figure
on page 8). This cable carries the following signals:
à la page 13).
(see figure 2, on page 4) for 10/100Base-T Ethernet
E
2,
on page 4). The port includes the
F
on page 10 for wiring details).
Contact Closure Communication
XTP T USW 103 Switcher • Installation
2, on page 4) and the XTP
D
TP Cable Termination
Remote power
RS-232
Tx Rx G
RS-232
Tx Rx G
RS-232 and IR
figure 2, on
G
Signal
Link
on
IR
Tx Rx
IR
Tx Rx
on
6