General tab
Click the
tab (see figure 25,
General
front panel lockout (executive) mode, auto switch mode, and factory reset.
Figure 25.
General Tab
Executive Mode panel
Unlock the Front Panel — Click the
2
disable front panel lockout (executive) mode.
Lock the Front Panel — Click the
3
front panel lockout (executive) mode (see
(Executive Mode)
on page 11).
Auto-input Switching panel
Auto-input Switching — Click the
4
enable auto switch mode. Two settings are available for this mode.
Click the
•
Priority to highest active input number
automatically switch to the highest numbered active input.
Click the
•
Priority to lowest active input number
automatically switch to the lowest numbered active input.
Factory reset
Click the
5
Factory Reset
firmware.
NOTE: This is the same as the
command on page 18).
XTP T USW 103 Switcher • XTP System Configuration Software
) to open the General screen. It contains settings for
1
Unlock Front Panel
Lock Front Panel
Setting the Front Panel Lockout Mode
Enable Auto-Input Switching
button to reset the transmitter to factory settings except for
E
SIS command (see the
ZXXX
radio button (default) to
radio button to enable
check box to
radio button to
radio button to
System reset
SIS
28