Setting Up The Chipscope Pro Software - Xilinx KC724 IBERT Getting Started Manual

4.
X-Ref Target - Figure 1-9
There is one IBERT demonstration design for each GTX Quad on the KC724 board, for a
total of four IBERT designs. Four other demonstration designs are included that show
other board features (the use of these designs are described in the README file within the
SD card). All eight designs are organized and stored on the SD card as shown in
Table 1-1: SD Card Contents and Configuration Addresses
5.

Setting Up the ChipScope Pro Software

1.
2.
KC724 IBERT Getting Started Guide
UG930 (v1.0) October 23, 2012
Select the GTX IBERT demonstration with the System ACE SD controller SASD CFG
switch, SW8. The setting on this 4-bit DIP switch
configure the FPGA. A switch is in the ON position if set to the far right and in the OFF
position if set to the far left. For the Quad 115 GTX IBERT demonstration, set
ADR2 = ON, ADR1 = ON, and ADR0 = ON. The MODE bit (switch position 4) is not
used and can be set either ON or OFF.
Figure 1-9: Configuration Address DIP Switch (SW8)
Demonstration
ADR2
Design
GTX Quad 115
GTX Quad 116
GTX Quad 117
GTX Quad 118
LED Scroll
DIP Switches
Push Buttons
USB/UART
Place the main power switch SW1 to the ON position.
Start the ChipScope Pro analyzer tools on the host computer and select
File → Open Project.
When the Project window opens, navigate to the directory where the ChipScope
software project files (.cpj) were extracted. Select kc724_q115.cpj and click Open.
Note:
The .cpj file loads pre-saved project settings for the demonstration including MGT/IBERT
and clock module control parameters. For more information regarding MGT/IBERT settings, refer
to UG029, ChipScope Pro Software Cores.
www.xilinx.com
Running the GTX IBERT Demonstration
(Figure
SASD CFG
SW8
ADR0
ADR1
ADR2
MODE (Not Used)
UG930_c1_09_101112
ADR1 ADR0
ON ON ON
ON ON OFF
ON OFF ON
ON OFF OFF
OFF ON ON
OFF ON OFF
OFF OFF ON
OFF OFF OFF
1-9) selects the file used to
Table 1-1.
13