Viewing Gtx Transceiver Operation - Xilinx KC724 IBERT Getting Started Manual

Chapter 1: KC724 IBERT Getting Started Guide
3.
X-Ref Target - Figure 1-14

Viewing GTX Transceiver Operation

After completing
configured and running. The status and test settings are displayed on the MGT/IBERT
Settings tab in the IBERT Console shown in
Note the line rate, TX differential output swing, and RX bit error count:
•
•
•
16
In the project panel, click IBERT Console
operation.
Figure 1-14: Project Panel - IBERT Console (GTX)
step 3 in Starting the SuperClock-2
The line rate for all four GTX transceivers is 12.5 Gbps (see MGT Link Status in
Figure 1-15).
The GTX transmitter differential output swing is preset to 850 mV.
Verify that there are no bit errors.
www.xilinx.com
(Figure 1-14) to view GTX transceiver
UG930_c1_14_101112
Module, the IBERT demonstration is
Figure 1-15.
KC724 IBERT Getting Started Guide
UG930 (v1.0) October 23, 2012