Extracting The Project Files - Xilinx KC724 IBERT Getting Started Manual

Extracting the Project Files

The ChipScope Pro Software .cpj project files for the IBERT demonstrations are located in
kc724_cpj.zip on the SD card provided with the KC724 board. They are also available
online along with .bit files for all four designs (as collection rdf0183_<ISE
version>.zip) at:
kc724_cpj.zip contains four project files: kc724_q115.cpj,kc724_q116.cpj,
kc724_q117.cpj, and kc724_q118.cpj. These files are used to load pre-saved
MGT/IBERT and SuperClock-2 module control settings for the GTX demonstrations.
To copy the files from the Secure Digital memory card:
1.
2.
3.
Running the GTX IBERT Demonstration
The GTX IBERT demonstration operates one GTX Quad at a time. This section describes
how to test GTX Quad 115. The remaining GTX Quads are tested following a similar series
of steps.
Connecting the GTX Transceivers and Reference Clocks
Figure 1-1
KC724 board.
Note:
KC724 IBERT Getting Started Guide
UG930 (v1.0) October 23, 2012
d. Screw down a 50Ω SMA terminator onto each of the six unused Si5368 clock
output SMA connectors: J7, J8, J12, J15, J16 and J17.
http://www.xilinx.com/kc724
Connect the Secure Digital memory card to the host computer.
Locate the file kc724_cpj.zip on the Secure Digital memory card.
Unzip the files to a working directory on the host computer.
shows the locations for GTX transceiver Quads 115, 116, 117, and 118 on the
Figure 1-1 is for reference only and might not reflect the current revision of the board.
www.xilinx.com
Extracting the Project Files
7