Editing An Existing Job - Challenge Spartan 185AEP Operator's Manual

Electronic programmable cutter

Table of Contents

6.0 Operation

Now enter send values by using any of the following methods: 1) Type in the desired value and press

ENTER, 2) Press ENTER at a blank line - this will enter the current position of the backgauge as a

send value. The first valued entered in a job will take 5 to 10 seconds.

When finished entering send values you may exit the current job by pressing soft-key "B" (EXIT to go

back to send mode. Or you may use the current job for cutting by pressing SEND.

6.13.2 Editing an Existing Job

6.13.2.1 Editing the Job Name

The job name can be edited (or added if an existing job does not have a name) in the job mode

screen. To edit the name, move the cursor down to the desired job number by pressing the down

arrow key. Then press the right arrow key to move the cursor to the desired character position and

edit the character by pressing the up or down arrow keys to toggle between characters of the

alphabet. Numbers can be entered directly by using the number keys. Pressing CLEAR clears the

current character. When finished, you may either go to the current job by pressing ENTER, or go to a

different job, or exit job mode.

6.13.2.2 Editing Send Values

To edit send values of an existing job, start by opening the desired job from the job mode screen. A

job is opened by one of two methods: pointing at the desired job with the cursor and pressing

ENTER, or by entering the job number with the keypad and pressing ENTER. Once a job has been

opened, the current job number will be displayed in the upper right corner.

Send values can now be edited by moving the cursor up or down to the desired send value and then

typing over the existing value.

When finished editing the job, you may exit the current job by pressing soft-key "B" (Exit) to exit to

send mode. Or you may use the job for cutting since it is already open.

6.13.2.3 Inserting Send Values

To insert a send value, press the soft-key "A" (EDIT) then the sof-key"B" (INSERT). This moves all

send values down and provides a blank line after the current send value.

6.13.2.4 Erasing Send Values

To erase a send value, press the soft-key "A" (EDIT) then the soft-key "A" (DELETE)This will remove

the cut value currently being pointed to by the cursor. To backspace over the current send value

without removing the line, press the left arrow key.

5.123

PRESS SEND

1>5.500

2 6.456

3 7.500

A:DELETE B: INSERT

Table of Contents