Table of Contents
Advertisement
6.13 Job Mode
The Spartan 185 AEP can be programmed for up to 20 different jobs or channels. A job is used for
making a sequence of cuts using the send (or cut) values of the job as the backgauge positions for
each cut. Each job can hold up to 25 send values. When the job mode is entered, all previously
programmed jobs will be displayed along with their name. An example of a job mode screen display
is shown below. Job 1 is always 10-BNSCARD. This job is used to cut 10 business cards form
8.5X11 stock.
6.13.1 Creating a New Job
To create a new job, type in a number that is not already assigned to a job and press ENTER. The
cursor will move to the line corresponding to the number you typed in, prompting you for a job name.
If no job name is desired, simply press ENTER again to begin entering send values (see below). To
name the job, press the right arrow key to move the cursor to the first character position. Enter a
character of the alphabet by using the up and down arrow keys to toggle to the desired character.
The numeric keys can be used to enter numbers directly into the job name. When the desired
character is in place, use the right arrow key to move to the next character position. The job name
can be up to 10 characters long. A letter can be removed from the job name by moving the cursor to
the undesired character and pressing the CLEAR key. When finished, press ENTER to save the
name and to begin entering send values. The screen should now look similar to the one shown next:
6.13.1.1 Entering Send Values
SELECT JOB 1-20
>
1> 10-BNSCARD
2> TESTJOB
5>
6> BOBS JOB
7> 8.5 X 11
B: Exit
SELECT JOB 1-20
>
1> 10-BNSCARD
2> TESTJOB
5>
6> BOBS JOB
7> 8.5 X 11
B: Exit
5.123
5
SEND TO RUN JOB
1>
A:EDIT
B: EXIT
6.0 Operation
19
Advertisement
Table of Contents
