Table of Contents
Advertisement
6.0 Operation
6.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL
YOU HAVE THOROUGHLY READ AND UNDERSTAND ALL OF THE FOLLOWING
INSTRUCTIONS. CALL YOUR AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY
QUESTIONS.
6.1 Power – Main Switch
Power is enabled when the main power switch is turned to the "ON" position (Figure 6). The display
and line light are turned on at this time.
Figure 6 –Power On-Off Switch and Circuit Breaker
If the knife is not at the "up" postion when the main power switch is turned
on, the knife will automatically move to the "up" position.
NOTE: The main power switch is also a circuit breaker and will automatically switch off in the event
of too much current running through the switch, such as from an electrical short. To reset the circuit
breaker, simply push the switch to the "on" position.
6.2 Power Clamp Breaker Switch
The machine will not operate if the Power Clamp Breaker Switch is tripped. If the switch is tripped,
reset the switch by locating the switch on the bottom side of the machine and pressing in the button
(Figure 7).
Tripped
Reset
Figure 7 – Power Clamp Breaker Switch
11
Advertisement
Table of Contents
