7. Falling Edge
For Falling Edge application, the DO value will be activated to logic high, when DI
value is changing from logic high to logic low (it is so-called falling edge). But the DO
value won't continuously remain logic high. Instead, after a specific period (in the
example project, it is 1 second), the DO value will back to logic low. The time chart is
shown as below:
You can see the DO 0 will only be triggered when falling edge of DI 0 occurs. In the
example project we provide, the DO status will remain logic high for 1 second. Then it
will back to logic low. When PLC is used for this kind of application, the ladder dia-
gram will be likely as below:
115
ADAM-6200 User Manual