Lenze 9215 Operating Instructions Manual page 75

Code Name Parameter
C370* Automation
interface
C380 RP-set speed _xxxxx Display range:
(L) (corresponds to
C046)
C381 RP-n _xxxxx Display range:
set2
(L)
(corresponds to
C050)
C382 RP-actual _xxxxx Display range:
(L) speed
(corresponds to
C051)
C387 RP-set torque _xxxxx Display range:
(L) (corresponds to
C056)
C388 RP-M _xxxxx Display range:
limit
(L) (corresponds to
C047)
C391 RP-act. angle
(L) (corresponds to
C060)

-0- Automation interface active
Automation interface inactive
-1- The automation communication must
be activated when using an auto-
mation module or a field bus connec-
tion LECOM2. If the communication is
enabled, without communicating to
the other side, the controller remains
inhibited. The communication via the
automation interface can be activated
independently of the operatíng mode
C001 when the controller is inhibited
(C040 = 0).
Caution!
To ensure a faultless initialization, the
LECOM interface may only be
accessed after one sec.
Note:
The setting will not be overwritten
when loading factory setting!
(8000 rpm = 26844)
Step: 1
(8000 rpm = 26844)
Step: 1
(9765 rpm = 32767)
Step: 1
Note:
Quick display without time message!
Step: 1
Step: 1
xxxxx Display range:
Step: 1
Accept-
ance
-26844...+26844 ON-LINE
-26844...+26844 read only
-32767...+32767 read only
-32767...+32767 read only
(100% = 32767)
-32767...+32767 ON-LINE
0...65535 read only
(360° = 16384)
see
page
71