Sokkia SRX1 Operator's Manual page 77

2. Start measurement.
Press [DIST] in the first page of Meas mode to
start measurement.
The measured distance data (S), vertical angle
(ZA), and horizontal angle (HAR) are displayed.
3. .Press [STOP] to quit distance measurement.

• If the single measurement mode is selected, measurement automatically stops after a single
measurement.
• During fine average measurement, the distance data is displayed as S1, S2,... to S9. When the
designated number of measurements has been completed, the average value of the distance is
displayed in the "SA" line.
• The distance and angle that are most recently measured remain stored in the memory until the
power is off and can be displayed at any time by pressing [RCL].

Allocating [RCL]: "21.6 Allocating Key Functions"
14. DISTANCE MEASUREMENT
69