Sokkia SRX1 Operator's Manual page 15

• Never point the laser beam at mirrors, windows or surfaces that are highly reflective. The reflected
laser beam could cause serious injury.
• When using the laser-pointer function, be sure to turn OFF the output laser after distance
measurement is completed. Even if distance measurement is canceled, the laser-pointer function is
still operating and the laser beam continues to be emitted. (After turning ON the Laser-pointer, the
laser beam is emitted for 5 minutes, and then automatically switches OFF. )
• Only those who have been received training as per the following items shall use this product.
• Read the Operator's manual for usage procedures for this product.
• Hazardous protection procedures (read this chapter).
• Requisite protective gear (read this chapter).
• Accident reporting procedures (stipulate procedures beforehand for transporting the injured and
contacting physicians in case there are laser induced injuries).
• Persons working within the range of the laser beam are advised to wear eye protection which
corresponds to the laser wavelength of the instrument being used
• Areas in which the lasers are used should be posted with laser warning notices.
• If Search or Track is selected in the Motor configuration "A.T. Setting", the laser beam will be emitted
from the objective lens when tracking a moving prism or searching for the center of the prism.

Tracking settings: "12.1 Auto Tracking Settings"
• The LED beam is emitted when the guide light is set to ON and the power is turned ON. Before
turning ON the power check that there are no persons in the LED beam path. Alternatively, always
set the guide light to OFF when you have finished measurement.

Guide light settings for tasks other than setting-out: "14.2 Using the Guide Light"

Guide light settings for setting-out: "14.2 Using the Guide Light"
3. LASER SAFETY INFORMATION
7