Sokkia SRX1 Operator's Manual page 101

6. Position the target on the line of sight and press
[DIST] to begin distance measurement.
The distance and direction to move the target until
the setting out point is located is displayed on the
SRX. The sighting point measurement results
(currently installed position of the target) are
displayed.
• Movement indicator (Red indicates that target
position is correct)
Arrows indicating horizontal direction will point in
the opposite direction when viewing the display in Face 2.
: (Viewed from SRX) Move target to the left
: (Viewed from SRX) Move target to the right
: Target position is correct
▼ : (Viewed from SRX) Move target closer
▲ : (Viewed from SRX) Move target away
▲▼ : (Viewed from SRX) Target position is correct
: Move target upward

: Move target downward

: Target position is correct

• Each time [/Shvr] is pressed, the distance input mode changes from "H" (horizontal distance),
"V" (height difference), "R" (REM), and "S" (slope distance).
• Press [CNFG] to set setting out accuracy. When the position of the target is within this range
both arrows will be displayed to indicate that the target position is correct.
17. SETTING-OUT MEASUREMENT
Arrows indicate direction to move
93