2.4.5 Dynamic Host Configuration Protocol (DHCP) Assignment
Description
It is possible to assign this PBX as a Dynamic Host Configuration Protocol (DHCP) client, allowing IP addresses
to be received from a DHCP server over a LAN.
Conditions
•
It is possible to enable this feature through system programming.
Notice
It is important to set your DHCP server to not change the IP addresses of the MPR and DSP cards once
IP telephones are registered to the PBX. The IP telephones will not operate properly if these IP addresses
are changed.
PC Programming Manual References
3.4 [1-1] Slot—Card Property - IPCMPR (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IPCEMPR
(for KX-TDE600)—LAN Setting
→
DHCP Client
→
IP Address for IPCMPR Card (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IP Address
for IPCEMPR Card (for KX-TDE600)
→
IP Address for VoIP-DSP
2.4.5 Dynamic Host Configuration Protocol (DHCP) Assignment
Feature Guide
465