Panasonic KX-NCP500 Features Manual page 393

Pure ip-pbx
Hide thumbs Also See for KX-NCP500:
Table of Contents

Advertisement

Through system programming, it is possible to assign a maximum number of "hops" (transfers between
PBXs) that extension status information can travel. Each time a piece of extension status information is
forwarded to another PBX, its counter is increased by one. When this counter reaches the assigned
maximum, the data is discarded. This is used to prevent data from circling unnecessarily around the
network.
® 11.2 [9-2] Network Data Transmission—
Feature—Data Transmission Counter
If it is not possible to remotely turn off transmission of extension status information using the NDSS Monitor
Release feature because of network conditions, it is possible to perform the same operation directly through
system programming at the monitored PBX.
® 6.8 [4-1-6] Wired Extension—NDSS Link Data - Send
® 6.15 [4-2-4] Portable Station—NDSS Link Data - Send
When using a VoIP network, if extension status information is lost by the network, in some cases an NDSS
button may not be able to display the status of the relevant extension.
NDSS cannot be used when two PBXs are networked using the [TIE Call by Own PBX Extension
Number] feature (® 1.30.1 TIE Line Service).
PC Programming Manual References
3.33 [1-1] Slot—Port Property - BRI Port—ISDN CO—
3.35 [1-1] Slot—Port Property - PRI Port—CO Setting—
4.12 [2-7-1] Class of Service—COS Settings—Manager—
6.5 [4-1-4] Wired Extension—Flexible Button
Type
Dial (for NDSS)
6.8 [4-1-6] Wired Extension—NDSS Link Data - Send
6.13 [4-2-3] Portable Station—Flexible Button
Type
Dial (for NDSS)
6.15 [4-2-4] Portable Station—NDSS Link Data - Send
6.17 [4-3] DSS Console
Type
Dial (for NDSS)
11.2 [9-2] Network Data Transmission
11.3 [9-3] Network Operator (VoIP)
11.4 [9-4] NDSS Key Table
PT Programming Manual References
[511] Manager Assignment
Feature Guide References
1.30.1 TIE Line Service
1.30.2 Voice over Internet Protocol (VoIP) Network
1.30.4 QSIG Standard Features
User Manual References
1.2.1 Basic Calling
2.1.7 Releasing Network Direct Station Selection (NDSS) Monitor
Network Data Transmission for Centralised Operator
Networking Data Transfer
Networking Data Transfer
Manager
1.30.5 QSIG Enhanced Features
Feature Guide
393

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents