Panasonic KX-NCP500 Features Manual page 445

Item
Set ICD groups as
DIL destination for
individual trunk
lines
*1
DHCP Client
LAN Connection
*2
Virtual Card
*1 This setting is displayed only if an ELCOT/LCOT card is already installed when Quick Setup is performed.
If the DHCP Client setting is set to Enable, this parameter cannot be set.
*2
Note that the programmable items may vary depending on the version of Maintenance Console being used.
Parameter
Yes/No
Enable/Disable
•
IP Address for MPR
Card
•
IP Address for
VoIP-DSP
•
Subnet Mask
•
Default Gateway
–
Description
Selecting Yes configures the settings of the
ELCOT/LCOT card and ICD groups as follows:
•
The floating extension number of each ICD
group is assigned sequentially to the DIL
destination of each port of the LCOT card.
→
12.2 [10-2] DIL Table & Port
Settings—DIL—
Lunch, Break, Night
•
The first 32 extensions are assigned as
members of every ICD group.
→
5.14 [3-5-1] Incoming Call Distribution
Group—Group Settings—Member List
•
Group Call Waiting Distribution is enabled for
each ICD group.
→
5.13 [3-5-1] Incoming Call Distribution
Group—Group Settings—Main—
Waiting Distribution
The effect of these settings is that calls arriving on
different trunks simultaneously will cause
corresponding S-CO buttons on PTs to light. This
configuration is useful in situations such as in a
general office.
When features such as ICD Group Queuing are
required, such as in a call centre, select No.
Determines whether to use a DHCP server to assign
IP address information automatically or not.
Manually enter the LAN information when not using
a DHCP server.
Select whether to install a V-IPEXT, V-SIPEXT, or
V-SIPGW card.
2.3.4 Quick Setup
DIL Destination—Day,
Call
Feature Guide 445